How to Install a Jeep Mesh Top Sunshade

One of life's greatest pleasures is riding in a Jeep with the top off. Every Jeeper enjoys the sensations of the wind blowing all about them, the warmth of the world surrounding them, and the closeness to the environment. The strength of the sun's rays is one feeling that most Jeepers could live without.

In this educational blog, we'll demonstrate how to put a mesh top on a Jeep Wrangler. You must first learn how to install this Jeep shade cover before you can enjoy driving with the top off while protecting your skin with this Wrangler sunshade.

Step 1. Remove the tops

Not surprisingly, removing the existing toppers is the first step in installing a Jeep JKU shade. If you're considering this product, you've likely already driven a Jeep without the top on and discovered that the heat from the sun didn't feel pleasant. However, if you're a more proactive thinker and have already planned ahead, you may need to know how to remove the present top.

It would help if you first unhooked the driver's side plug that connects your top to your car. Next, be careful to remove the screws holding your top in place. Then, make sure you raise straight up to avoid being caught in the little guide poles that hold the top in place for the time being.

Store the top in a dry, secure location to prevent any damage or rusting.

Step 2. Assign the straps to the holes

Your kit of covers and cords should also include instructions. These instructions will help you arrange your different-sized cords. Every length of the cord is made to be taut enough to ensure security while still providing enough slack to fit around the cage's various locations.

Your first step should be sorting your cords by length. After that, insert the wires through the holes in the blinds so you can keep them organized and remember where they belong. Before proceeding to the next step, confirm that each one is safe in its designated spot.

Step 3. Wrap the cords around the frame

One end of the cords will have a ball, while the other will have a loop. Verify that the sun top cover is facing the correct direction before placing the ball on top of the sunshade and guiding the loop through the opening and downward. Once everything is in its proper place, you can start looping the cord around the frame.

Stretch the elastic as far as possible by pulling down on the cord, then re-wrap it around the frame to the top. If it cannot, you might have the incorrect cord in place or an obstruction, such as an open visor, preventing the cord from wrapping entirely around the frame.

Ensure to attach the rope to the ball once it is completely around. It should be easy to extend the cable but fit snugly. A cord is probably not in the proper place if it is either too tight or loose.

Step 4. Drive or Put the tops back on.

You can replace the tops and leave them in this position when all the cords are fastened. Therefore, you would only need to complete this installation once if desired. Before you drive again, make sure the tops are attached.

You are welcome to try out the new Jeep mesh tops now.

Conclusion

So, overall, the installation process is straightforward. 

  1. Put the cords in the appropriate slots.
  2. Encircle the frame with the cords.

Although the process can be painful, you should have little trouble following these guidelines and exercising caution!