How To Install Jeep Wrangler Aftermarket Fenders

The fenders of your Jeep Wrangler are readily scratched and scraped by dirt, gravel, and grime. Many Jeep owners decide to replace their damaged fenders with aftermarket ones because they don't look good on any Jeep. New fenders can also shield your Jeep's body from pebbles and other debris that your tires may occasionally kick up. Fender installation can be done by you or by hiring a mechanic. Fortunately, the procedure is relatively easy and should take fifteen minutes or so. Find out how to install aftermarket fenders on a Jeep Wrangler below.

Remove Old Fenders

The existing fenders must be removed from your car before you can install the aftermarket ones. Fortunately, this procedure is simple and should only take about five to seven minutes for a single fender. Follow these easy methods to get rid of the old fenders.

  • Start by unplugging the fender light. To accomplish this, reach beneath the fender's light and unplug it.
  • Every bolt and clip holding the fender to the car should be taken out.
  • Then, slowly and steadily raise and remove the fender from the car.

Line Up New Fender

Now that the old ones have been removed, it's time to install the new ones. The first step is to align the new fender with the car. Next, make sure you have a wrench, the fender liner, and all the bolts you'll need.

Place Fender Liner On Fender

You can start fastening the fender to the car after making sure you have all the tools you need. Put the rubber fender liner between the fender and the Jeep and press the fender against the vehicle. After that, you may start putting the bolts in and manually tightening them. Working with a helper who can keep the rubber liner in place while you tighten the fasteners is beneficial throughout this procedure. It's advisable to have someone hold this rubber liner while you tighten the bolts because it can be challenging to keep it in place.

Tighten Bolts

By now, the liner between the car and the fender should be well secured. You can use a wrench to firmly fasten the fender to the car after all the bolts are in place. Prior to completing this procedure, you must ensure that all bolts are firmly attached.

Repeat

If step four was correctly completed, one aftermarket fender should be firmly attached to the car. The next step is to replace the other fender. To do so, follow the previous instructions.

Now that you have this knowledge, you can install aftermarket fenders on a Jeep Wrangler. Tube and flair fenders are among the many varieties of fenders that you can add to your car. Visit Ledlightjeep website to buy new Jeep Wrangler JK fender flares for your vehicle. There are several Jeep aftermarket parts available here that will provide your car with more protection and style.